ABB Protection Realy(REF615) Communication to NOC0401 with M340 PLC over Unity Pro S

HimDwi

Member
H
Join Date
May 2015
Location
Noida
Posts
1
Hello Everyone,
I am using BMXP341000 Processor with communication module NOC0401 and programming software is Unity Pro S v8.0 . I have a ABB protection relay REF615. I want data from this relay to my NOC module over MODBUS TCP/IP network. Can anyone tell what will be the procedure to get data values in my logic ?
 
Where do we start? I think the easiest is to get the noc user manual on schneiders website.
It shows examples of connecting to equipment of modtcp and ethernet ip
 

Similar Topics

EICS
ABB PS501 Control Builder Plus V2.3 Install - anyone use it or know of it
does anyone have an install or know if/where i can download it for the following "ABB PS501 Control Builder Plus V2.3 " the software was a free...
Replies
2
Views
92
ojz0r
O
S
IE5 ABB motor and VFD
Hello, It is mandatory to use VFD IF i use IE5 electrical motor? What happens If connect it directly as delta without VFD? Please look at motor...
Replies
1
Views
150
kamenges
K
R
ABB ACS800-07 VSD fault on ramp up between 98 and 100%
Hi hoping someone can assist me with current issue I am experiencing with an ABB drive. Problem I’m experiencing is a ABB drive supply a large...
Replies
4
Views
214
BryanG
B
R
ABB AC500 (PM573-Eth) PLC Program Backup
Hello all, I have an ABB PLC (PM573) and it has without MC card. I need to take backup from PLC to PC (in automation builder v2.7 ). My...
Replies
10
Views
452
arpus4KM
A
O
Remote Connection to ABB MOD300 OPC Server - Difficult or Impossible
Folks, I have a client with an old ABB Advant / MOD300 system (v14.4). Around y2k I installed the ABB Industrial IT MOD300 OPC Server 1.1/2...
Replies
1
Views
185
odwyerpw
O
Back
Top Bottom