ALlen Bradley 931N Signal conditioners

Prankzbhardwaj

Member
P
Join Date
May 2020
Location
California
Posts
1
Hi,
I am trying to connect several 931N-T221 to Logix 5000 PLC ( 1756-IF8 module) going over the documentation, I found that it can support both differential and single ended inputs. But I am not sure about 931N series conditioner, they are not loop powered but I am not sure if I should use them as Single ended of Differential input to the module.
Any suggestions?

Thanks :)
 

Similar Topics

D
Getting connected to Allen Bradley Ultra3000
Hi how's it going. Was just wondering if someone could help me out. Recently one of the guys over on the LinuxCNC forums put me onto getting an...
2
Replies
15
Views
227
plvlce
P
N
2707-NC5 Allen Bradley Cable Pinout
Hello, Does anyone have one of these cables and willing to open the case so I can see the cable connections inside? 2707-NC5 I have sourced the...
Replies
3
Views
84
Mickey
Mickey
P
Allen Bradley Parts
Currently trying to find: micrologix ethernet interface 1761-NET-ENI AIC to micrologix 761-CBL-AM00 Ser C cable These are used for micrologix...
Replies
3
Views
133
tlf30
tlf30
U
allen bradley kinetix 300 E11 fault code
in allen bradley kinetix 300 drive first E31 error shows after resting drive E11 error occurs need solution to reset E11 fault code
Replies
4
Views
173
robertmee
R
R
Allen-Bradley Analogue Input 1756-IF16 Scaling
Hi, I have a ControlLogix system with 1756-IF16 analogue inputs. I can't scale the inputs at the card as there is a requirement to facilitate...
Replies
14
Views
459
Rich0147
R
Back
Top Bottom