sapoleon
Member
Hi all,
I'm in a project now, where I neet to read 4 Shinko ASC that are connected in modbus RTU 485, to an Adam 4572 (Modbus RTU to Modbus TCP/IP).
Up to that point there is no problem, the Adam is respondig nice, and working OK against the 4 Shinko. I tested it with modpoll with good results.
So, the problem arrives when I connect it to Cimplicity 6.1. I need to read one point form the Shinko (40129) that is the PV, and write to another one that is the SP (40002).
The thing is that cimplicity does not see the points. I configured a port for Modbus TCP (MASTER_MBTCP10), and then the devices (HEATPIPE 1 .. 4) with model STAT_PLC and the ip@ 1 ..4 for every device.
The thing is that when I insert the points, it says that they are not valid....
If someone need more details, or if someone have any idea, I'll gladly appreciate it.
Thanks
I'm in a project now, where I neet to read 4 Shinko ASC that are connected in modbus RTU 485, to an Adam 4572 (Modbus RTU to Modbus TCP/IP).
Up to that point there is no problem, the Adam is respondig nice, and working OK against the 4 Shinko. I tested it with modpoll with good results.
So, the problem arrives when I connect it to Cimplicity 6.1. I need to read one point form the Shinko (40129) that is the PV, and write to another one that is the SP (40002).
The thing is that cimplicity does not see the points. I configured a port for Modbus TCP (MASTER_MBTCP10), and then the devices (HEATPIPE 1 .. 4) with model STAT_PLC and the ip@ 1 ..4 for every device.
The thing is that when I insert the points, it says that they are not valid....
If someone need more details, or if someone have any idea, I'll gladly appreciate it.
Thanks