alive15
Member
Good morning, I am having some issues connecting to my plc via ethernet. There is a 9-pin RS232 I can connect to however.
The ethernet cable runs from PLC to an unmanaged switch, which goes to the outside of my control panel. I know the ethernet port is working, cause it's communicating well with my robot via ethernet (fanuc r30iA). Funny enough, it does not communicate with my C-more hmi however.
When I open RS Linx, it sees the ip address of the plc, but when I press the '+' next to it, RS Linx freezes for few seconds, then the '+' changes to '-', but nothing it shown below it.
I can ping both my plc and hmi via my laptop however?
Any troubleshooting help is appreciated, thanks!
The ethernet cable runs from PLC to an unmanaged switch, which goes to the outside of my control panel. I know the ethernet port is working, cause it's communicating well with my robot via ethernet (fanuc r30iA). Funny enough, it does not communicate with my C-more hmi however.
When I open RS Linx, it sees the ip address of the plc, but when I press the '+' next to it, RS Linx freezes for few seconds, then the '+' changes to '-', but nothing it shown below it.
I can ping both my plc and hmi via my laptop however?
Any troubleshooting help is appreciated, thanks!