Controllogix SSV to change Absolute Feedback Offset Value

ryman1998

Member
R
Join Date
Nov 2010
Location
United States
Posts
5
Currently I use an MRP (Motion Redefine Position) to adjust position. Is there an SSV where I can directly change the absolute feedback offset for an axis in a motion group? I've seen an article that references that it is available, but I haven't found how to do it. Any help would be appreciated.

Cheers!
 
what are you trying to do?

MRP is the correct way to do it - and is available during motion but not while a MAR on input 2 is active

I use MRP once on power up then do not need to touch it again
 

Similar Topics

Z
using SSV to set wallclock for controllogix
I have problem to set wallclock for controllogix by using SSV.
Replies
4
Views
2,828
zakwan
Z
Christoph
ControlLogix GSV & SSV instruction
All I am studying a PLC program from another facility. It uses an SSV instruction and a GSV. Data in SSV, GSV as follows...
Replies
4
Views
7,464
harryting
H
V
TWIDO WITH CONTROLLOGIX
Hello everyone, has anyone managed to communicate Twido with Controllogix using the Ethernet connection?
Replies
1
Views
88
VitorPrado
V
L
Beckhoff IPC and Controllogix PLC
I'm trying to integrate a Beckhoff IPC with a Controllogix PLC. There is some documentation, on the Beckhoff website, on how to do a PLC-PLC comms...
Replies
0
Views
153
lcabal27
L
T
ControlLogix Redundancy Module Single Mode Fiber
Why does the controllogix redundancy modules use a single mode fiber vs multimode fiber?
Replies
1
Views
117
Ken Moore
Ken Moore
Back
Top Bottom