FactoryTalk ME Comms question?

jasil

Member
J
Join Date
Jun 2012
Location
Building
Posts
48
Question-

I was given a Micrologix .RSS file and a .APA file communication is ethernet.

I was asked to verify comms ethernet (which they are).

IT has given them a new IP range to use. They said they will change the Micrologix IP address, sub, gateway via the display and the HMI IP address, sub, gateway if I can change the FactoryTalk application.

I have never tried this before I have always been able to go online and test.

If I change the runtime target to the new IP address (only option I see) will the comms establish?

commspic.jpg
 

Similar Topics

N
FactoryTalk Studio SE Comms setup not working
im looking for some help. im looking at redirecting some tags from one PLC to a new one with a different address. when i go online on FT SE and...
Replies
0
Views
441
nlansley
N
N
FactoryTalk No Ethernet Comms
So when I go to communication setup in factory talk view studio and I create a shortcut and click on the tab Local Runtime and choose Ethernet...
Replies
4
Views
1,926
nik124
N
A
Factorytalk view clients freeze everytime I add a new routine in studio 5000
As the title says, all of the client HMIs at the plant freeze up for about 5-10 minutes everytime I or a vendor make new routines or new tags in...
Replies
1
Views
44
saultgeorge
saultgeorge
U
Factorytalk View ME with RSLogix500 with SLC5/03 PLC
Hello, I want to connect the Factorytalkview ME with rslogix500 to see the live response of HMI buttons in Rslogix500 ladder code . I am using PLC...
Replies
6
Views
115
thinkpad
T
L
FactoryTalk Linx Ethernet config error
Hello everyone I have the next issue with FactoryTalk Linx, when i configure the Ethernet driver and try to find the IP Address of the PLC Device...
Replies
0
Views
67
Lawrence Alcocer
L
Back
Top Bottom