dylantzips
Member
Let me start off by saying that I am a CO-OP student and I am very new to PLC's.
For my current project I am trying to figure out how to set up Alarms on an HMI. This is the program that was handed off to me: http://prntscr.com/jrpt90.
I have already made a DINT array to have enough values for all of the fault codes. I understand how to link tags from the PLC to the HMI. However, I am not sure how to make the PLC show which fault code is being tripped and then output that code to the HMI.
This is what I have so far and it could be completely wrong: http://prntscr.com/jrpuyd. Would this work?
Sorry if some of my wording does not make sense, I am still learning a lot about PLC's and logic. If what I am doing is wrong, could anyone help steer me in the right direction?
Thanks.
For my current project I am trying to figure out how to set up Alarms on an HMI. This is the program that was handed off to me: http://prntscr.com/jrpt90.
I have already made a DINT array to have enough values for all of the fault codes. I understand how to link tags from the PLC to the HMI. However, I am not sure how to make the PLC show which fault code is being tripped and then output that code to the HMI.
This is what I have so far and it could be completely wrong: http://prntscr.com/jrpuyd. Would this work?
Sorry if some of my wording does not make sense, I am still learning a lot about PLC's and logic. If what I am doing is wrong, could anyone help steer me in the right direction?
Thanks.