Hello,
Concept: Input should remain for a given time so as for the PLC to look into.
What to do if my input can change its value, which is less than cycle time?
There are three ways:
1. Hardware side: the input module shall extend this particular input pulse even physically input is absent for the required time.
2. Use seperate function modules.
3. Some software commands used in programming...I do not know??
Concept: Input should remain for a given time so as for the PLC to look into.
What to do if my input can change its value, which is less than cycle time?
There are three ways:
1. Hardware side: the input module shall extend this particular input pulse even physically input is absent for the required time.
2. Use seperate function modules.
3. Some software commands used in programming...I do not know??