uptown47
Lifetime Supporting Member
Hi all,
I was under the impression that Load and Transfer operate independantly of the RLO ?
If this is the case the following code shouldn't work, but it does...
This code only loads 20 into MW50 if I0.0 is on. However, if the Load was operating independantly of the RLO it would load 20 into MW50 all the time ?
If L and T do look at the RLO before executing, why does the LADder MOVE command of the same code above need to convert to...
Can anyone explain this to me as I'm getting confused about this.
Many thanks
;-)
I was under the impression that Load and Transfer operate independantly of the RLO ?
If this is the case the following code shouldn't work, but it does...
Code:
A I 0.0
L 20
T MW50
BEC
This code only loads 20 into MW50 if I0.0 is on. However, if the Load was operating independantly of the RLO it would load 20 into MW50 all the time ?
If L and T do look at the RLO before executing, why does the LADder MOVE command of the same code above need to convert to...
Code:
A I0.0
JNB _001
L 20
T MW50
_001: NOP 0
Can anyone explain this to me as I'm getting confused about this.
Many thanks
;-)