Russ
Lifetime Supporting Member
Hi,
We're upgrading a plc5 to control logix and are using a dhrio card to communicate with the DH+ network... but I can't figure out the bridging.
The plc 5 message instruction looked like this:
Data table address: N15:15
Local node (octal): 75
Local remote: remote
Remote link: type: remote
Remote station address: 40
Remote bridge: 2
What do I do? The dhrio is in slot 1.
We're upgrading a plc5 to control logix and are using a dhrio card to communicate with the DH+ network... but I can't figure out the bridging.
The plc 5 message instruction looked like this:
Data table address: N15:15
Local node (octal): 75
Local remote: remote
Remote link: type: remote
Remote station address: 40
Remote bridge: 2
What do I do? The dhrio is in slot 1.