Hello Experts,
i am new to this forum,
we have control techniques mentor-2 DC drives for Conveyor application,
Q.1) in motor standstill condition motor not showing zero speed feedback,
it shows zero speed feedback only when we set keypad to 1.11 or 3.13 visualization (we don't understand why this is so- pls give suggestion on this ).
Q.2) in other application when drive stop and start again motor not rotating & drive shows negative speed indication- here when we rotate conveyor once manually (spanner etc) motor start rotating normally (this also we are unable to understand- give some idea on same also.)
thanks in advance.
i am new to this forum,
we have control techniques mentor-2 DC drives for Conveyor application,
Q.1) in motor standstill condition motor not showing zero speed feedback,
it shows zero speed feedback only when we set keypad to 1.11 or 3.13 visualization (we don't understand why this is so- pls give suggestion on this ).
Q.2) in other application when drive stop and start again motor not rotating & drive shows negative speed indication- here when we rotate conveyor once manually (spanner etc) motor start rotating normally (this also we are unable to understand- give some idea on same also.)
thanks in advance.