phuz
Member
Just finished an upgrade from a SLC500 to CLX where they had a 1746-HSCE and we're now using a 1756-HSC. Two wire pulse signal from the micromotion mass flow meter. A+ / A- on the old card, and electrician hooked up to terminals 14/18 on 1756-HSC which looks like 12/24vdc and I'm wondering if the A+ needs to be on #16 for +5vdc. I can't find any info on what voltage the micromotion pulse is, but I would suspect 5.
Having a strange issue where the totalizer seemed to be operating correctly, and then on the next batch it was completely off. I also have the 1756-HSC on Counter mode with no filter enabled.
Having a strange issue where the totalizer seemed to be operating correctly, and then on the next batch it was completely off. I also have the 1756-HSC on Counter mode with no filter enabled.