Hi all.
I am having problems trying to set up a Mitsubishi FX3G PLC with a FX2N-32CAN module attached to it. I am trying to get it to talk to some Nord Gear SK500E Inverters with built in CANopen.
I can get the PLC to switch into Operational Mode but I am having problems getting the Nord inverter into Operational mode. When I send the operational mode command to the PLC it puts the inverter into PRE-Operational mode.
Can anyone give me an insight into what commands I need to send to the inverter so that it will switch into operational state.
The mitsi manual can be found here http://download.mitsubishi-automation.com/resources/manuals/149771.pdf?form_submit=View+now
The nord manual can be found here http://www2.nord.com/cms/media/documents/bw/BU0030_GB_5104.pdf
Thanks in advance
Jonathan
I am having problems trying to set up a Mitsubishi FX3G PLC with a FX2N-32CAN module attached to it. I am trying to get it to talk to some Nord Gear SK500E Inverters with built in CANopen.
I can get the PLC to switch into Operational Mode but I am having problems getting the Nord inverter into Operational mode. When I send the operational mode command to the PLC it puts the inverter into PRE-Operational mode.
Can anyone give me an insight into what commands I need to send to the inverter so that it will switch into operational state.
The mitsi manual can be found here http://download.mitsubishi-automation.com/resources/manuals/149771.pdf?form_submit=View+now
The nord manual can be found here http://www2.nord.com/cms/media/documents/bw/BU0030_GB_5104.pdf
Thanks in advance
Jonathan
