Welshy
Member
Hi everyone,
I'm currently configuring a Q-series PLC (Q10UDEHCPU), using GX Wroks 2, and a Q71E71-100 Ethernet communication module to facilitate comms. Ethernet communication seems to be working fine, I am sending/receiving data between a HMI via a ethernet switch but I've noticed the COM ERR LED light is red on the ethernet module.
On the ethernet diagnostics page of GX Works 2, I can see the following errpr detail:
Error End COde: C080
Sub Header: 0000
Command COde: 0000
Connection No.: 0012
Host Station Port No. : 0000
Destination I.P Address: 0.0.0.0
Destination Port No. : 0000
I've looked up the error code and searched in the code for issues tjhat may be causing this but I'm at a loss as to what could be causing this error, and how I should resolve it.
I currently have 3 open settings for the ethernet card, 1 direct connection to the HMI and 2 melsoft ones.
Any help would be greatly appreciated.
I'm currently configuring a Q-series PLC (Q10UDEHCPU), using GX Wroks 2, and a Q71E71-100 Ethernet communication module to facilitate comms. Ethernet communication seems to be working fine, I am sending/receiving data between a HMI via a ethernet switch but I've noticed the COM ERR LED light is red on the ethernet module.
On the ethernet diagnostics page of GX Works 2, I can see the following errpr detail:
Error End COde: C080
Sub Header: 0000
Command COde: 0000
Connection No.: 0012
Host Station Port No. : 0000
Destination I.P Address: 0.0.0.0
Destination Port No. : 0000
I've looked up the error code and searched in the code for issues tjhat may be causing this but I'm at a loss as to what could be causing this error, and how I should resolve it.
I currently have 3 open settings for the ethernet card, 1 direct connection to the HMI and 2 melsoft ones.
Any help would be greatly appreciated.