Multiple Comm paths factory talk view ME V6.1

[DUNK]

I have no problems setting up a single communications path In FTV ME. How would you go about setting up 1 application to communicate to multiple PLC's via Ethernet IP?

 

[Bob O]

It would be the same..meaning just add the shortcut and point it to the controller and repeat.

HTH

 

[bernie_carlton]

Just make sure the second shortcut, and all following, have unique names.

 

[DUNK]

I must be missing something. I added each controller, all have different names. When I Clicked OK it only tells me of the one change and not all 3.

 

[Bob O]

Add your shortcut and then select the controller and then select apply and repeat. I also think you when your all done you may have to hit verify and ok in the lower right hand corner but that could be just a habit of mine.