battmiceter
Member
I have recently replaced an old Panelview with a new Panelview Plus 1000. It communicates with the old SLC PLC over a DH+ network.
All the existing wiring is the same, ive literally just swapped the screen.
But I cant get it to display anything from the PLC and all the analogue values just display question marks.
Ive converted the old panelbuilder32 file to a factory talkview file and added the DH+ in the network comms under RSenterprise.
The PLC is node 1, ive tried the HMI as node 0, 2, 3, 4.
There are no other devices on the DH+ network, but still nothing.
Im pretty sure ive done everything right unless anyone can advise me.
Ive also been told a story that new panelviews have trouble commumicating with the old PLC's, I don't know how true this is thow.
Any advice at all would be helpful.
Thanks,
Luke.
All the existing wiring is the same, ive literally just swapped the screen.
But I cant get it to display anything from the PLC and all the analogue values just display question marks.
Ive converted the old panelbuilder32 file to a factory talkview file and added the DH+ in the network comms under RSenterprise.
The PLC is node 1, ive tried the HMI as node 0, 2, 3, 4.
There are no other devices on the DH+ network, but still nothing.
Im pretty sure ive done everything right unless anyone can advise me.
Ive also been told a story that new panelviews have trouble commumicating with the old PLC's, I don't know how true this is thow.
Any advice at all would be helpful.
Thanks,
Luke.