ckchew666 Member Join Date Aug 2003 Location Malaysia Posts 591 May 17, 2006 #1 Hi, Does anyonere here has experience in IMCS? I'd like to know what is the software & cable to program the IMCS 4100-214-R ser D Hope someone can guide me on this. Thanks.
Hi, Does anyonere here has experience in IMCS? I'd like to know what is the software & cable to program the IMCS 4100-214-R ser D Hope someone can guide me on this. Thanks.
Gerry Member G Join Date Jun 2002 Location Auckland Posts 1,142 May 17, 2006 #2 The software is called GML Commander and you need a serial cable - can't remember if straight or crossover. GML = Graphical Motion Language
The software is called GML Commander and you need a serial cable - can't remember if straight or crossover. GML = Graphical Motion Language
ckchew666 Member OP Join Date Aug 2003 Location Malaysia Posts 591 May 17, 2006 #3 Gerry said: The software is called GML Commander and you need a serial cable - can't remember if straight or crossover. GML = Graphical Motion Language Click to expand... Thx for ur info, the cable is like 1747-CP3 or 2711-NC13?
Gerry said: The software is called GML Commander and you need a serial cable - can't remember if straight or crossover. GML = Graphical Motion Language Click to expand... Thx for ur info, the cable is like 1747-CP3 or 2711-NC13?
Gerry Member G Join Date Jun 2002 Location Auckland Posts 1,142 May 17, 2006 #4 As I said, I can't remember if the cable is straight or crossover. I've looked for info but can't find any. The NC13 might work. I believe it uses XON/XOFF protocol so only TX, RX, and GND required.
As I said, I can't remember if the cable is straight or crossover. I've looked for info but can't find any. The NC13 might work. I believe it uses XON/XOFF protocol so only TX, RX, and GND required.