heather.banks
Member
Hello All,
I am working with a powerflex 525 trying to get multiple speed references. I got it working on my bench and then I went out to the field only to find that the control voltage running the drive is 18 VAC. I can't seem to figure out where the 18 VAC is originating from. The drive start, stop, reverse, ect. is all controlled off of 18 VAC. I did not even think that it would work in this fashion. I was hoping someone could shed some light on this.
I am working with a powerflex 525 trying to get multiple speed references. I got it working on my bench and then I went out to the field only to find that the control voltage running the drive is 18 VAC. I can't seem to figure out where the 18 VAC is originating from. The drive start, stop, reverse, ect. is all controlled off of 18 VAC. I did not even think that it would work in this fashion. I was hoping someone could shed some light on this.