Powerflex 700 Display and leds flash when power is removed

M1WC316

Member
M
Join Date
Dec 2010
Location
Illinois
Posts
6
Hey I was wondering if any one has had this problem before,
I powered down a Powerflex 700 and the Display and leds flash and keep flashing. The drive has been powered of for 24 hours now and its still flashing.
I am using a 110 v input card. which still has power. Tried pulling it off still flashes. have not checked to see if I have any back feed voltage.
 
Did you call AB Tech support? You don't need a TechConnect contract for help with VFDs. If you wait until after hours, you leave a message and someone calls you back within the hour, but if you call during the work day, you usually get right through (after you navigate through the automated phone tree)

(262) 512-8176
 

Similar Topics

A
Communication Issues between PowerFlex 700 and M580 Controller
Hello, I am currently in the final week of my internship and I have encountered issues with communication between a PowerFlex 700 variable...
Replies
0
Views
37
asmer
A
T
Powerflex 700 Losing Ready Status at the beginning of shift.
I've got a Powerflex 700 that doesn't like to get going in the mornings. This motor will run anywhere from 30 seconds to 5 minutes before it just...
Replies
3
Views
197
ASF
A
Y
Viewing Modified Parameters on PowerFlex 700 VFD
Looking for some assistance. I am very familiar with Yaskawa VFDs, but not so much with AB VFDs. I am working on some hardwired AB PowerFlex 700...
Replies
2
Views
149
alan_505
A
M
Powerflex 700 dno file printed out
Can someone with Drive Executive please save me a printout of the parameters for this drive in this file. I'm in a bind and would greatly...
Replies
2
Views
370
muusic_man
M
A
Powerflex 700 / 70
Hello all, I was forced to replace a Powerflex 700 to a Powerflex 70 due to what is available. The digital input parameters (361-366) have a...
Replies
1
Views
493
robertmee
R
Back
Top Bottom