Kimmerrild
Member
I'm no genie on PLC's.
I'm elektrician of craft, so I have the basics of it. anyhow.
I have bought myself a LOGO! 12/24RCE witch I wanna connekt 4 sensors of PT1000.
How is it that I wireconnekt the sensor to the PLC?
It's a 2wire cable that runs to the sensor. it regulates on 0-10V correkt?
I have some 6,6kohm resistors, but nomatter how I try to connekt the stuff together, it dosent seems to work when i go in "online test" with the LOGO. it either say 1000 or 0 in the "internal value"
Sooo.
How do I figure this out, anyone?
Thanks in adv.
Kim.
I'm elektrician of craft, so I have the basics of it. anyhow.
I have bought myself a LOGO! 12/24RCE witch I wanna connekt 4 sensors of PT1000.
How is it that I wireconnekt the sensor to the PLC?
It's a 2wire cable that runs to the sensor. it regulates on 0-10V correkt?
I have some 6,6kohm resistors, but nomatter how I try to connekt the stuff together, it dosent seems to work when i go in "online test" with the LOGO. it either say 1000 or 0 in the "internal value"
Sooo.
How do I figure this out, anyone?
Thanks in adv.
Kim.