Question about reversing servo direction on Mitsubishi MR-J2S-40A

daveinarmstrong

Member
D
Join Date
Oct 2007
Location
Armstrong
Posts
4
I have replaced a drive a Mitsubishi MR-J2S-40A servo drive and now the servo is going in the wrong direction. instead of editing the code, i would like to just change 2 of the 3 wires to the servo. is it advisable on this type of servo drive?
Thanks in advance for your help.
 

Similar Topics

L
Question marks on every textbox of my aplication
I recently uploaded an aplication from a Panel View, created a new screen and now that I've downloaded it to the Panel View, all the texts have...
Replies
9
Views
155
LuisK_GB
L
P
Siemens 6ES7331-7KF02-OABO Wiring Question
I have never had the pleasure of working with a "Thermistor" until now and have a question. The Thermistor is a 10KOhm 4-20mA 2-wire device and I...
Replies
4
Views
138
parness45
P
P
JSR Execution Question
Hi All, So I have a main routine with an instruction that's executed by XIC "Run" I have a JSR located on a rung below it. In the logic for that...
Replies
6
Views
244
patrickmoneyy
P
O
AB 1769- L30 Input Card Question
I have a 120V relay, 120V DI card and a analog input. I was wanting to know if i could put a 24V DI and well as a 120V DI card on the same plc...
Replies
1
Views
104
joseph_e2
J
S
simple logic question
Hello again..trying something on an existing poorly written program and just wanted to double check something system is an A-B MicroLogix 1200 In...
Replies
5
Views
201
robertmee
R
Back
Top Bottom