cajunconfigurator
Member
Hello All,
I have an older Total Control Quick Panel QPI2D100L2P 10.4 inch Monochrome that I am trying to retrieve the program on. The original programmer is unknown and we do not have a copy of the program. The screen has gone out on this panel.
I am using quickdesigner on an XP virtual machine. I have the correct programming cable the 8 pin DIN connector HMI-CAB-C49-J
When I connect to the HMI, The software "sees" that the HMI is connected and says "waiting for the Display to be ready" then times out and tells me "the display is Hung" and another message "Turn display OFF" when I turn it off the software gives me the message "Turn Display ON" then when I turn it on, the software goes to "waiting for the Display device to be ready" and just sit there. Nothing more. I have waited for 20 mins for it to progress and nothing.
At first I thought maybe the Panel that I am working on is just bad. However I get the same indications on another, same model, quick panel that IS working just fine.
I know this is older stuff. And ProFace Support (who took over making the replacements from TCP) wont support using quick designer on anything other than a Win 2K machine or older.
Anyone have experience with these panels?
I have an older Total Control Quick Panel QPI2D100L2P 10.4 inch Monochrome that I am trying to retrieve the program on. The original programmer is unknown and we do not have a copy of the program. The screen has gone out on this panel.
I am using quickdesigner on an XP virtual machine. I have the correct programming cable the 8 pin DIN connector HMI-CAB-C49-J
When I connect to the HMI, The software "sees" that the HMI is connected and says "waiting for the Display to be ready" then times out and tells me "the display is Hung" and another message "Turn display OFF" when I turn it off the software gives me the message "Turn Display ON" then when I turn it on, the software goes to "waiting for the Display device to be ready" and just sit there. Nothing more. I have waited for 20 mins for it to progress and nothing.
At first I thought maybe the Panel that I am working on is just bad. However I get the same indications on another, same model, quick panel that IS working just fine.
I know this is older stuff. And ProFace Support (who took over making the replacements from TCP) wont support using quick designer on anything other than a Win 2K machine or older.
Anyone have experience with these panels?