beanpole_ecc
Member
@timbert
so if i'm reading that right, my situation could be satisfactory as far as the risk assessment is in line with what is wired. i didn't know about the falling edge specification, that's good knowledge to know.
now for a little gray area. What if the e-stop button is a three state push latched pull momentary button with the pull portion the reset button for the safety circuit? we have a couple of those on our OEM machines and i always thought that as a little fishy. haha. This is a good thread. Learning a lot.
so if i'm reading that right, my situation could be satisfactory as far as the risk assessment is in line with what is wired. i didn't know about the falling edge specification, that's good knowledge to know.
now for a little gray area. What if the e-stop button is a three state push latched pull momentary button with the pull portion the reset button for the safety circuit? we have a couple of those on our OEM machines and i always thought that as a little fishy. haha. This is a good thread. Learning a lot.