Hi. I have a ControlLogix PLC with a SERCOS card which is going to be connected to an AB Ultra3000 SERCOS drive.
Do I need to use an AB servo motor with this setup, or can I use a Kollmorgen?
I ask because the CN2 port on the Ultra3000(the encoder feedback) is a 15 pin port. I know AB servos have a 15 pin encoder pinout, but the Kollmorgen has an 8 pin encoder pinout on the servo.
Is it still possible to make this work?
Do I need to use an AB servo motor with this setup, or can I use a Kollmorgen?
I ask because the CN2 port on the Ultra3000(the encoder feedback) is a 15 pin port. I know AB servos have a 15 pin encoder pinout, but the Kollmorgen has an 8 pin encoder pinout on the servo.
Is it still possible to make this work?