SoMachineNetwork connection problem

Arslanafzal201 said:
I am trying to connect plc m340 with magelis gto hmithrough ethernet but hmi starts program runs but then display message " fail to open connection with plc then i open this messag it shows two errors "fail to open connection with plc" and second one " configure default setting' what i do now any one explain
Click to expand...

You should start a new thread as the m340 has nothing to do with somachine.
 

Similar Topics

M
HMI Connection - {::[PLC1]Program:#1.#3.Abc.Efg} What is the #1.#3 ?
I'm having a hard time either remembering or figuring this out. I have a PLC program and the associated HMI program. I know what this means...
Replies
4
Views
118
plvlce
P
B
Simulate Siemens HMI to PLC through NAT connection
Hello, I have an issue where I want to simulate an Siemens HMI panel, through NAT connection to a PLC. I have the possibility through extended...
Replies
8
Views
273
JesperMP
JesperMP
P
PG/PC ethernet connection
Hello guys i'm working with an s7 1200 plc with an ET 200S expansion module. The problem is that i can't find the plc when searching in the...
Replies
1
Views
122
RVaughan
RVaughan
S
Rockwell PLC Looses Connection Evrytime I reboot..
I have got an Rockwell PLC 1769-L36ERMS . I have assigned a IP address to it . But every-time I Reboot the PLC it looses Communication to my PC...
Replies
1
Views
114
Ken Roach
Ken Roach
S
TIA-portal - Adding connection to HMI in a different project
Hello all! So I have one project with a S7-1214 and a MTP1500 "Project1" and one project with another S7-1214 "Project2". Both of these PLC:s need...
Replies
6
Views
171
swedeleaner
S
Back
Top Bottom