highvoltage8471
Member
- Join Date
- Feb 2004
- Posts
- 84
Hi all,
I am using WinCC flexable v.2008 Sp2 and transfering project to a MP377 12" Touch HMI via mode ethernet / IP address. My issue is that I had downloaded or (Transfered) to 3 different HMI's fine with different IP's on the 4th HMI I had changed IP address and hit apply just like the last 3 but this time it transfered to the last HMI I have done. I checked and double checked to make sure IP's had accepted the change after hitting "Apply" and it did but no matter what IP I changed it to it still went to the same HMI. Has anyone had this happen to them or any ideas of what to look for? I tried a different Assbly line the following day and it downloaded the first HMI fine but when changed addresses it had done the same and would only go to the last HMI downloaded to. Any help would be appreciated.
I am using WinCC flexable v.2008 Sp2 and transfering project to a MP377 12" Touch HMI via mode ethernet / IP address. My issue is that I had downloaded or (Transfered) to 3 different HMI's fine with different IP's on the 4th HMI I had changed IP address and hit apply just like the last 3 but this time it transfered to the last HMI I have done. I checked and double checked to make sure IP's had accepted the change after hitting "Apply" and it did but no matter what IP I changed it to it still went to the same HMI. Has anyone had this happen to them or any ideas of what to look for? I tried a different Assbly line the following day and it downloaded the first HMI fine but when changed addresses it had done the same and would only go to the last HMI downloaded to. Any help would be appreciated.