Can anyone help me getting this comms connection set up?
I am using Port 2 on the Versamax ICU200UDR005-DK, set in SNP with port settings
Baud Rate 19k2
Stop Bits 1
Parity Odd
SNP ID 1
In the Redlion I am using SNP Master
Comms Settings 19k2
Baud Rate 19k2
Stop Bits 1
Parity Odd
SNP ID 1
Port Set to RS485 4 wire
I have made a cable up to run from the Redlion to Versamax as follows
Versamax 15 Pin D plug RedLion RJ45
7-----------------------------------------6
10 ---------------------------------------8
11----------------------------------------7
12----------------------------------------3
13----------------------------------------4
Using this configuration I cant appear to get any flicker of comms on the comms port indications.
Any help would be appreciated
I am using Port 2 on the Versamax ICU200UDR005-DK, set in SNP with port settings
Baud Rate 19k2
Stop Bits 1
Parity Odd
SNP ID 1
In the Redlion I am using SNP Master
Comms Settings 19k2
Baud Rate 19k2
Stop Bits 1
Parity Odd
SNP ID 1
Port Set to RS485 4 wire
I have made a cable up to run from the Redlion to Versamax as follows
Versamax 15 Pin D plug RedLion RJ45
7-----------------------------------------6
10 ---------------------------------------8
11----------------------------------------7
12----------------------------------------3
13----------------------------------------4
Using this configuration I cant appear to get any flicker of comms on the comms port indications.
Any help would be appreciated