Bobogrammer
Member
Good afternoon everyone!
Got roped into a project where they want to feed speed and distance values (INT or DINT) From a Unitronics HMI (SM70-J-R20) into a Yaskawa S5 Servo (MP2600). I figured out on the drive side the ethernet address and adapter to set up assembly instances, but I can't for the life of me figure out how to get the HMI ready to send and receive the data. It's not a lot, maybe 10 bytes each way, but this is the first time looking at either system. I'm a TIA Portal and Logix 5000 programmer, with SEW and Powerflex drive experience. These things are new so if you've got idea of what I need to do I'm all ears.
Thank you and Happy Holidays!
Bobo
Got roped into a project where they want to feed speed and distance values (INT or DINT) From a Unitronics HMI (SM70-J-R20) into a Yaskawa S5 Servo (MP2600). I figured out on the drive side the ethernet address and adapter to set up assembly instances, but I can't for the life of me figure out how to get the HMI ready to send and receive the data. It's not a lot, maybe 10 bytes each way, but this is the first time looking at either system. I'm a TIA Portal and Logix 5000 programmer, with SEW and Powerflex drive experience. These things are new so if you've got idea of what I need to do I'm all ears.
Thank you and Happy Holidays!
Bobo
