apolionman
Member
Hello Guys,
I'm trying to program S7 200 CPU 212 using USB/PPI mm ( 6ES7 901-3DB30 - 0XA0 ). Uploading the program from PLC is good but when I am trying to Download the program to PLC it says
"The firmware version in the attached PLC does not support the operation. You must put the cable into Freeport/PPI mode to when communicating with older PLCs."
I am wondering how to put the cable into Freeport/PPI?
Thank you advance guys.
I'm trying to program S7 200 CPU 212 using USB/PPI mm ( 6ES7 901-3DB30 - 0XA0 ). Uploading the program from PLC is good but when I am trying to Download the program to PLC it says
"The firmware version in the attached PLC does not support the operation. You must put the cable into Freeport/PPI mode to when communicating with older PLCs."
I am wondering how to put the cable into Freeport/PPI?
Thank you advance guys.