Fixed it, did a total deinstall, including key of WinCC, and used the cleanup utility.
Funny though last time WinCC was working fine with the last project, went to a project with Allen Bradley, worked with RS View and panelview, had to do an update in RSlogix 5000 with a profile update.
After that project back to a siemens project and voila compiling problems in WinCC.
I think AB and Siemens software under the same partition gives some conflicts.
Next laptop I will make 2 XP partitions with one Siemens software installed and one partition with AB installed.
My Current laptop takes 10 to 15 min. to boot up, to much
cr@p on the laptop, with too many conflicts.
For instance I have Installed:
S7 with HMI software WinCC and Protool
RS logix 500, 5000 with RSview and panelview
Indralogix with all Bosh Rexroth software incl. visual motion, and drivetop
Cognex insight software
PILZ Multi pnoz
Omron Software
Schneider Software
And the list goes on and on.
Last time a problem with drive top, could not find the comms server, turn out to be a windows protection DEP.
I guess I am trying to say... the joy of programming does not run over roses
Like I said next time 2 different partitions maybe even 3, on a flash drive (lot quicker) to prevent conflicts.