Karinrinkashi
Member
Hello everyone,
We have an L32 processor on 192.168.1.x subnet and our corporate is now asking us to connect all our machines to their network because they are working on a visualization software for machine performance. All of the other processors that we have are equipped with dual IP except for this one machine which has the older L32 processor which I mentioned above.
The corporate network is on 10.74.193.xxx subnet. I tried using the stratix switch VLAN routing but I could not get the corporate to see the PLC. The corporate is using a CISCO 900 switch on their end where the machine will connect to and they established a Vlan 300 on that switch with a specific port for this machine (again, subnet is 10.74.193.xxx).
Again, the devices at my disposal are the stratix switches and also I have a MOXA 102 NAT device.
Has anyone been able to achieve this and what device did they use? Any technical help will also be much appreciated.
regards,
Karinrinkashi
We have an L32 processor on 192.168.1.x subnet and our corporate is now asking us to connect all our machines to their network because they are working on a visualization software for machine performance. All of the other processors that we have are equipped with dual IP except for this one machine which has the older L32 processor which I mentioned above.
The corporate network is on 10.74.193.xxx subnet. I tried using the stratix switch VLAN routing but I could not get the corporate to see the PLC. The corporate is using a CISCO 900 switch on their end where the machine will connect to and they established a Vlan 300 on that switch with a specific port for this machine (again, subnet is 10.74.193.xxx).
Again, the devices at my disposal are the stratix switches and also I have a MOXA 102 NAT device.
Has anyone been able to achieve this and what device did they use? Any technical help will also be much appreciated.
regards,
Karinrinkashi