hunter44102
Member
So our Powerflex 525's are set up to allow REMOTE operation from PLC through network. But if network is lost we want to be able to run in LOCAL with local display panel.
However when network is lost we get a fault. There is a Parameter 'comm loss action' C125:
0= FAULT
1= Coast Stop
2= Stop
3= Continue LAST
Do I just set it to anything OTHER than 0 so that it doesn't get a FAULT which prevents it from starting LOCALLY?
So basically if our network goes down we would like to switch the dial to LOCAL and input the speed and start it locally but whoever configured this system didn't test what happens if network disconnects.
However when network is lost we get a fault. There is a Parameter 'comm loss action' C125:
0= FAULT
1= Coast Stop
2= Stop
3= Continue LAST
Do I just set it to anything OTHER than 0 so that it doesn't get a FAULT which prevents it from starting LOCALLY?
So basically if our network goes down we would like to switch the dial to LOCAL and input the speed and start it locally but whoever configured this system didn't test what happens if network disconnects.