AB RsNetWorx

Hi all,

I am new to AB world and particulary to RSNetWorx. A customer asked me to program a SmartGuard 600 with safety point I/O and standard I/O. I can't figure how to configure I/O of the standard I/O.

Here is the material :

1 x 1752-L24BBBE
1 x 1734-PDN
4 x 1734-IB8S
1 x 1734-OB8S
3 x 1734-OB8

I managed to configure safety I/O, but I need some help to configure the standard I/O.

Anyone already done this kind of configuration ?

Any help will be appreciate

Here is a copy of my project.

If someone could take a look at it and give me a hint on how to achieve it. I am pretty sure that it is easy to do, but I do not know how and I do not have access to the hardware to do some testing


I have read this manual http://literature.rockwellautomation.com/idc/groups/literature/documents/rm/1752-rm001_-en-p.pdf

The only thing I understand is that the points I / O standard should be set as Slave I / O. But, I do not understand how to specify bytes created in the Slave I / O tab to which nodes communicate.

I finally had my answer.

You can not use Point I / O standard with a SmartGuard.

Thank you to all

Good to know - I thought that was the case but wasn't sure enough to say it out loud

Thanks for posting the follow up, will probably help others in the future!

The project engineer told me we could. I spent several hours trying to get communication between the two.

But you know, he will pay the bill!