zacslade
Member
Hi All,
I am starting a project where I have a 1769-L33R which will communicate with modbus devices by means of a MDS TSXEGT100 Modbus Gateway. I'm still waiting on part numbers for the ethernet devices, but I want to get ready because this project doesn't have a lot of available time.
I haven't worked on this kind of protocol conversion before. In your experience, would it be normal for me to just add a Generic Ethernet Module for each modbus device in Logix Designer, and then input assembly instances, etc?
Thanks!
I am starting a project where I have a 1769-L33R which will communicate with modbus devices by means of a MDS TSXEGT100 Modbus Gateway. I'm still waiting on part numbers for the ethernet devices, but I want to get ready because this project doesn't have a lot of available time.
I haven't worked on this kind of protocol conversion before. In your experience, would it be normal for me to just add a Generic Ethernet Module for each modbus device in Logix Designer, and then input assembly instances, etc?
Thanks!