Good Afternoon ,
I have a scraper on a machine that I would like to display it's position on a Panelview Plus. The scraper position is sending a 4-20 ma signal into a analog input card. The operator cannot physically see the position , so I would like to display it on the screen. I am just using a rectangle to try the horizontal positioning . I selected .....
Tag's Min & Max and I set the pixel offset at Min and Max from 0 - 165.
The tag I have attached is Scraper Position. It is a REAL number. I also did it with a DINT. When I do a test run ,I keep getting "Unable to Animate Polygon"
Within the expression , I can use just a tag ,correct ? The value in the position is from 1.213 to -.250
What could I be doing wrong ?
Thanks in advance ,
I have a scraper on a machine that I would like to display it's position on a Panelview Plus. The scraper position is sending a 4-20 ma signal into a analog input card. The operator cannot physically see the position , so I would like to display it on the screen. I am just using a rectangle to try the horizontal positioning . I selected .....
Tag's Min & Max and I set the pixel offset at Min and Max from 0 - 165.
The tag I have attached is Scraper Position. It is a REAL number. I also did it with a DINT. When I do a test run ,I keep getting "Unable to Animate Polygon"
Within the expression , I can use just a tag ,correct ? The value in the position is from 1.213 to -.250
What could I be doing wrong ?
Thanks in advance ,