Profibus statusword

ivahu

Member
I
Join Date
Nov 2004
Posts
1
I am involved in a project where a Siemens PLC is to be substitutetd with a Mitsubishi PLC.
The Siemens PLC communicates with several Profibus nodes.
We have test-connected the Misubishi as Profibus Master and are able to read status words from slaves.
How to evaluate the content of the Status words?
Slaves are:
Siemens Micromaster 4
Siemens Simocode-DP
(We have succeded with Siemens ET200 and DP/AS-Interface.)
 

Similar Topics

U
Using 2 cables on a Profibus connector
Hi, I was noticing that Profibus connectors have 2 ports on them that can house 2 separate cables. Can I use 2 cables with Profibus signals...
Replies
4
Views
178
Ken Moore
Ken Moore
U
Setting up WAGO PFC 200 750-8216 as a Profibus Slave
Hello, I am in possession of a WAGO PFC 200 750-8216 which I was successfully able to set up as a Modbus RTU Master to a slave device using...
Replies
0
Views
81
udit_91
U
A
Component selection and Implementation of Profibus
I am trying to implement a profibus network and am a newbie in the automation and communication industry. what are the components required for the...
Replies
1
Views
105
mk42
M
R
S7 Device Proxy Profibus Diagnostics
Hi, I am using TIA Portal V18. I have imported a (v5.7) SIMATIC manager project via device proxy. I have created a HMI project (TP700) in TIA...
Replies
2
Views
319
mk42
M
T
Profibus Cable 830-IT
Hi Folks, I am new to the S7-300 and the whole Profibus communication. And I just wonder that can you connect a S7-300 module to a Beckhoff Bus...
Replies
1
Views
318
JRW
JRW
Back
Top Bottom