Omron CJ1M & Panelview Micro 300
- Thread starter donl517
- Start date
ArikBY
Member
I dont think so.
I checked in the PB there is no option for direct communiction between Micro 300 to CJ1.
I checked in the PB there is no option for direct communiction between Micro 300 to CJ1.
Similar Topics
Hi dear . I have a system with cj1m cpu11 etn. previously NT 5z HMI was connected with plc. recently my old HMI got damaged. I want to replace it...
hi dear all hope you all are fine
I have a problem with my CJ1M cpu11 ETN. it stop communication with PC over ethernet. ETN unit all indications...
Hello everyone. I am new when it comes to Omron PLCs.
Currently I'm uploading program from CJ1M PLC using CS1W-CIF31 cable only. I connected the...
i have been trying to connect to omron cj1m via peripheral port(USB to Serial), but there isn't any sign to show that it has connected, so am...
Has anyone encountered an error code 31 on an omron cj1m-cpu12? This error code is not covered in PLC manual.