W8WCA
Member
Hello:
While cleaning out my basement I found a unused D100CRA14.
I have manuals, and two adaptors a 25 pin to what is a Cat 5 looking plug, and I have a 9 pinRS232 to RS485 adaptor also.
I had a cable but lost it. (Looks like a straight thru CAT 5 might work.
I downloaded the recommended Toshiba software for it, and it runs
BUT it wants a Hardware Key. Me orig. D100/D300 software did not require a Hardware key.
So if anyone has the Cutler Hammer software could I get a copy of it?
Thanks All
Charlie Alexander
While cleaning out my basement I found a unused D100CRA14.
I have manuals, and two adaptors a 25 pin to what is a Cat 5 looking plug, and I have a 9 pinRS232 to RS485 adaptor also.
I had a cable but lost it. (Looks like a straight thru CAT 5 might work.
I downloaded the recommended Toshiba software for it, and it runs
BUT it wants a Hardware Key. Me orig. D100/D300 software did not require a Hardware key.
So if anyone has the Cutler Hammer software could I get a copy of it?
Thanks All
Charlie Alexander