Pic 900
- Thread starter Hawgwild
- Start date
Hi Hawgwild
You have to write the ip configuration to the module itself. If I remember correctly stop scan, put your program cable on the lower port of the TCP/IP module, (using picpro for windows)go to the online tab, control operations, configure TCP/IP. There you can read or write the configuration to the module.
Hope this helps ya.
You have to write the ip configuration to the module itself. If I remember correctly stop scan, put your program cable on the lower port of the TCP/IP module, (using picpro for windows)go to the online tab, control operations, configure TCP/IP. There you can read or write the configuration to the module.
Hope this helps ya.
Similar Topics
I have an OEM machine that runs on 8 Giddings & Lewis PiC-900's
I can change programs between the sections with PiCPro V15.1 Monitor Edition
My...
Hello! My company is still using the old DOS software Ver 9.0 to troubleshoot a PIC 900 ( model 918??? cpu ) plc. I am tring to talk them into...
This is the motor nameplate from one of the powder hoist motors on the USS Texas an older generation battle ship, built in 1911-1914 ish.
The...
Hello,
I'm am engineer for a plastic manufacturer. We swapped out a oem motor with one of equivalent nameplate stats made by marathon on our roll...
good afternoon all
I had to pull out the old 1747-pic module my question it has a 25 pin connection I need to go to a 9 pin connection do pin 2...