mrsoliveira
Member
Hello all,
I need use a
I need use a
Shift Register Matsushita
- Thread starter mrsoliveira
- Start date
mrsoliveira
Member
OP
Shift Register help
Hello all,
I need use a Shift Register how a FIFO (First In First Out), but in my PLC don't have FIFO function.
This PLC have a function "F119" as PDF attached
I put this signals:
input - [0=Fail /1=Pass) of the inspection in my part.
shift_trigger - Rising Edge of Sensor part
Where i read the correct bit (here 4) to decision if segregate the part?
Hello all,
I need use a Shift Register how a FIFO (First In First Out), but in my PLC don't have FIFO function.
This PLC have a function "F119" as PDF attached
I put this signals:
input - [0=Fail /1=Pass) of the inspection in my part.
shift_trigger - Rising Edge of Sensor part
Where i read the correct bit (here 4) to decision if segregate the part?
Similar Topics
I am attempting to reject a bottle If the label fails. The rejection works fine at normal line speed but at low speed the rejector fires (air...
Hi guys,
I am pretty new when it comes to programming. I am working with CX-Programmer and I am having a problem where I have a sensor on my...
Hi all,
i have a very slow indexing machine where we are looking to make everything as bulletproof as possible, money is not much of a factor...
Good morning (EST),
I am trying to implement the code below in on an S7-1200. It's barely half a dozen instructions, but I am stuck; I have not...
Hi everyone
I am completely new to using shift registers and am a bit stuck, my shift register works as should, it is for an overhead conveyor...