Is it possible to connect a GE Fanuc I/O (via EGD) to an Allen-Bradley's plc?
- Thread starter clvitor
- Start date
Similar Topics
I recently inherited some 5/04 CPUs and a single 5/02 CPU that I need to pull the programs from. The 5/04 CPUs didn't pose any problems. I...
Hi,
I have AB Micro820 PLC (2080-LC20-20QBB) which, acc. to the specs, can be both Ethernet/IP master and slave.
I need it to be a master and...
Hello Guys, can you give me a tip?
I am designing a Filter Press Station and I can't afford to buy HMI panels so I am going to use my PC as HMI...
Hi Gents, this is a tricky one. I am waiting to receive an actual Modicon M340 PLC, but I would like to test my code. Is it possible to connect...
I was wondering in you could gain access of a plc that is connected by dial-up modem on one end and me through the internet on the other ..is...