Hi guys,
Anyone using Festo servo motor with the software named ServoWave SA3? The hardware is SLME2305-300-WGAPS.
I'm having problem connecting the n/book with the servo drive. The software value read from the software are changing, but actual the servo motor & drive are not running at all, I'll get comm error message "COmmunication went wrong" when i tried to read the parameters settings from the drive.
I'm using ServoWave SA-3 version 1.01E. Is there any newer version out there?
I've check my serial port and there is no problem, I can online with MLX 1000. The cable I've put it in my festo suppiier and he can online with the servo drive. So, my only suspect is the SA3 s/w conflict with other softwares.
Any advice for me? Thanks.
Anyone using Festo servo motor with the software named ServoWave SA3? The hardware is SLME2305-300-WGAPS.
I'm having problem connecting the n/book with the servo drive. The software value read from the software are changing, but actual the servo motor & drive are not running at all, I'll get comm error message "COmmunication went wrong" when i tried to read the parameters settings from the drive.
I'm using ServoWave SA-3 version 1.01E. Is there any newer version out there?
I've check my serial port and there is no problem, I can online with MLX 1000. The cable I've put it in my festo suppiier and he can online with the servo drive. So, my only suspect is the SA3 s/w conflict with other softwares.
Any advice for me? Thanks.
