Hello, I installed a brand new 1756-DNB card and I proceeded to set the node address. To do this, I pressed and held down the manual config button and watched the node addresses cycle through on the little display window. As it cycled through the different addresses it suddenly stopped and displayed a BT61 message code and I couldn't do anything else.
I checked the rockwell knowledge base and they indictated this is a message you get when a flash fails. Since this devicenet card is brand new and I wasn't trying to flash it... this message shouldn't have came up.
Do you think this card is defective and I should return it?
-Pete
I checked the rockwell knowledge base and they indictated this is a message you get when a flash fails. Since this devicenet card is brand new and I wasn't trying to flash it... this message shouldn't have came up.
Do you think this card is defective and I should return it?
-Pete