Is there someway to copy out an S7 FB as STL and edit it using Notepad++.
It doesn't seem to want to work, ie no paste to Notepad++.
I turned the comments off in S7 thinking that was it, but no luck.
Thanks in advance
I'd like to be able to do this because then I can churn out a whole lot of similar logic easily and without fat fingers.
It doesn't seem to want to work, ie no paste to Notepad++.
I turned the comments off in S7 thinking that was it, but no luck.
Thanks in advance
I'd like to be able to do this because then I can churn out a whole lot of similar logic easily and without fat fingers.