schneider lxm05 and Twido (CanOpen)

musaratm

Member
M
Join Date
Aug 2009
Location
@ home
Posts
2
Lexium 05 works perfectly when controled via PowerSuite, but i can not control it via Twido (CanOpen). Can You send me simple program, where Twido sends Lexium command, just to rotate BSH motor at some speed ( for exemple 2000 rev/min).
I have LXM05AD10M2 , TWDLMDA20DRT with Can expansion module, BSH motor and TwidoSuite 2.01.
It would be very helpfull.
 

Similar Topics

K
Schneider Modicon Premium TSX P57203Controller issue
Everything was working fine, but suddenly CPU went into error mode, and the ERR and TER LEDs lit up. Now I can't download or connect with the PLC...
Replies
0
Views
39
[email protected]
K
S
NTP for Schneider M580/M340
Hello all, I am wanting to update the system clock via NTP in the M580/M340. I'm aware that we are able to connect to a NTP in the controller...
Replies
4
Views
129
S.Woollett
S
M
Pack drive elau Schneider ISH-100
I am using Schneider elau pack drive servo motor ISH-100. I am facing the problem that On the ISH -100 red light is blinking and pack drive C-600...
Replies
0
Views
61
Munish
M
P
How to connect to Schneider M241 PLC remotely from EcoStruxure Machine Expert software using SSH tunnelling?
Hello, As part of our project, we are using an M241 controller. This controller interfaces with an industrial computer and a router via a switch...
Replies
2
Views
105
Para
P
J
Schneider M221 ModBus RS-485 Communication
Hello, I need to access the bits from the fire system control panel through RS-485. So, I used Read Var block to read from the panel...
Replies
0
Views
187
jillgeorge18
J
Back
Top Bottom