How to configure the Wago PFC with Beckhoff I/O?

Dear,I want to use the wago PFC750-842 as controller,and want to use the analog input of Beckhoff KL3314(4 input for thermoelments with wire breakage identi),i use WAGO I/O PRO32 OR WAGO CAA,but i don't know how to configure the module,because the controller is wago,i/o belong to Beckhoff,and the software was developed by wago,so anyone can tell me how to resolve it.
best regards.

well sorry that is not possible as the speed on the bus is different for beckhoff and wago, the hardware is the same but the software is not.

however also wago could help you with this and if they cant i can for sure.