How to read symbols from Simotion SCOUT project? i have a PC application which can communicate to Simotion PLC (via Ethernet RFC1006) and read Input & output.
But the symbols which are defined i can not read it and also no idea how or where this is stored in the project.
(where as in case of S7300/400 PLC, i can always read all the data using direct addressing like MW, IW, QW etc..)
any suggestions?
Thanks in advance!
But the symbols which are defined i can not read it and also no idea how or where this is stored in the project.
(where as in case of S7300/400 PLC, i can always read all the data using direct addressing like MW, IW, QW etc..)
any suggestions?
Thanks in advance!