Hello plc people!
I posted this a few weeks ago and was asked to get some pic;s
encoder along with fiber optics
flywheel proxy switching every 0.75 sec.
bar at 2400deg. entering shears racheting 1/4 turn every 0.75sec.
I am doing the logic with simple timers and limits to change the frequency drive according to when the leading edge crosses the optic it sends the acc. pulses to a reg. read by limit blocks and switches freq. for said duration to try and bring leading edge at a sweet spot into the racheting shears to get a full cut rather than a short cut. I know there is a better way of using my encoder along with the flywheel proxy and could use alittle advise.The flywheel has a fixed speed rotation and I have banged my head trying to figure this out..y=mx+b.
Thanks yall!
I posted this a few weeks ago and was asked to get some pic;s
encoder along with fiber optics
flywheel proxy switching every 0.75 sec.
bar at 2400deg. entering shears racheting 1/4 turn every 0.75sec.
I am doing the logic with simple timers and limits to change the frequency drive according to when the leading edge crosses the optic it sends the acc. pulses to a reg. read by limit blocks and switches freq. for said duration to try and bring leading edge at a sweet spot into the racheting shears to get a full cut rather than a short cut. I know there is a better way of using my encoder along with the flywheel proxy and could use alittle advise.The flywheel has a fixed speed rotation and I have banged my head trying to figure this out..y=mx+b.
Thanks yall!
