A-B Microview

bfjou812

Member
bfjou812
Join Date
Nov 2009
Location
Winter haven Fl.
Posts
9
Hi, I'm trying to hook up a microview touchpad and would like to know which part of the dc receptacle is + and which is - I can't seem to find any information on the A-B site .Maybe not looking in the right place ? Thanks for the help, Jeff
 
What is the entire part number of the "microview"?

If it is a panelview 300 micro, I think I have one I can look at for you. IIRC, the polairty marks were on the removable connector.
 
If your panel is cat#2711-M3A18L1 your dc positive is the one next to the RS232 receptacle the configuration is rs232 receptacle + - and ground at the end
 
Thanks for the help, here is the complete catalog number 2707-MVP232 Ser .B It is 11 - 25 VDC, When looking at the receptacle I need to know if the post in the center is positive or negative. Again, thank you very much for your help. Jeff
 
Last edited:

Similar Topics

C
AB MicroView Problems
Hi all, I recently purchased a machine that has/had 2MicroLogix 1000 PLC's with 2 MicroViewpanels. The previous owner stripped out one of the...
2
Replies
19
Views
6,156
sigmadelta
S
T
AB MicroView 2707-MVP232
Trying to find the software to upload the application of this interface. I'm going to a site tomorrow - the customer wants a backup for this...
Replies
2
Views
1,199
ThomasGruetter
T
N
Slc 5/03 and microview 2707-mvp232
The microview is made for the micrologix plcs, is it possible to use it with scl 5/03 serial port? and if yes, what is the cable pinout? thanks
Replies
1
Views
1,509
Lancie1
Lancie1
F
A-B Microview comm.
I have an A-B Microview (cat #2707-MVP232) connected to a Micrologix 1000 (cat #1761-L32 BWA). I purchased another one and want to set it up so it...
Replies
9
Views
3,112
roadwhore
R
D
microview 2707 access code
Hi does any one know how to get past the limited access code which comes up when pushing the mode key on the microview. thankyou
Replies
1
Views
2,078
rPraveenkum
rPraveenkum
Back
Top Bottom