Horner XE102 Menu Screen misbehaving

rmb550

Member
R
Join Date
Nov 2009
Location
Ontario
Posts
86
We have a menu programmed into our XE102, and found when we navigated to it, it was flashing and did not accept input.
By poking around a bit, we found a Register Number over 18000 in the "Enables" box. When we cleared that box the problem went away.
I tried to understand the Help file write up on the Enables box but still do not get it. Can someone clarify what it is?
Also, can someone explain how such a crazy register number ended up in there?
Thanks,
rmb
 

Similar Topics

R
HORNER XE102 Programming Connection
I have a Horner HE102 with the Ethernet Card. I have set the IP address to 198.168.1.4, and I have set my laptop to 198.168.1.3. I have connected...
Replies
2
Views
2,949
rmb550
R
D
Reset PLC Horner?
I was loading a program onto an XE1e2 PLC and it got stuck on these two windows and won't progress. It won't let me connect from the PC to reload...
Replies
0
Views
73
Data_name
D
J
simulation setup using horner OCS using structured text (Cscape)
I am trying to set up a piece of equipment with a Horner HE-X4R. I'd like to use structured text and so far I'm just trying to get a basic On/off...
Replies
0
Views
70
jdk202
J
D
Plc Horner Modbus Error
I am having a problem communicating my PLC with Drive via Modbus connection. I start by opening the port and there is no problem, but then when I...
Replies
6
Views
200
Data_name
D
A
Horner XL7 PLC and Eaton MMX VFD Control signal issue.
Hello, I’m new to this forum and if I’m posting incorrectly let me know. I’ve been having an issue I can’t seem to figure out. I’m sure it’s...
Replies
1
Views
119
bkottaras
B
Back
Top Bottom